ADTRAN Atlas 550 System Manual page 219

ATLAS 550 System Manual
R > IP > R
OUTER OUTES
Read security: 2
Displays the number of times the router has referenced this route.
R > IP > R
OUTER OUTES
Write security: 2; Read security: 2
Clears the menu and resets the value to zero.
U
SED
R > IP > R
OUTER OUTES
Read security: 2
Indicates the properties of this routing table entry, composed of the following letters:
H –
route is a host route
–
G route is a gateway route
DR –
route learned dynamically from RIP
–
I
route learned from an ICMP redirect
A –
route learned from IARP
P –
route is private and is not advertised with RIP
T –
route is to a triggered port (updated only when table changes)
R > IP > R
OUTER OUTES
Read security: 2
Displays the number of router hops required to get to the network or host. Ranges from 0 to 16. If set to 16,
the route is defined as infinite and cannot be used.
R > IP > R
OUTER OUTES
Read security: 2
Displays the total cost of sending a packet to the specified network. Normally, the cost is based on the
available bandwidth.
R > IP > R
OUTER OUTES
Read security: 2
Displays the number of seconds until the address is removed from table. A value of
static.
R > IP > I
OUTER NTERFACES
Write security: 2; Read security: 2
The menu configures and monitors all interfaces connected to the ATLAS router. These
I
NTERFACES
include the Ethernet and frame relay DLCIs connected in the
61200305L2-1B
> U
SED
> C
LR
> F
LAGS
> H
OPS
> C
OST
> TTL
© 2004 ADTRAN, Inc.
Section 4 User Interface Guide
999
P M / P
ACKET ANAGER ACKET
means the route is
.
C
NCTS
219