Dlp-7 Updating The Firmware Using Xmodem - ADTRAN Atlas 550 System Manual

DLP-7 Updating the Firmware Using XMODEM

Introduction
The ATLAS 550 supports firmware updates using TFTP or XMODEM. (Use the 10/100BaseT
port and TFTP from a network server, or use XMODEM and the
ETHERNET
interfaces.) This procedure outlines the steps for a successful firmware upgrade using the
interfaces and XMODEM software. (See DLP-6, Updating the Firmware Using TFTP, for
CRAFT
instructions on using TFTP.)
Tools and Materials Required
• VT100 terminal or PC with VT100 terminal emulation software
• XMODEM software
To prevent electrical shock, do not install equipment in a wet location or during a
lightning storm
Electronic equipment can be damaged by static electrical discharge. Before handling it,
put on an antistatic discharge wrist strap to prevent damage to electronic components.
Place equipment in antistatic packing material when transporting or storing. When
working on equipment, always place it on an approved antistatic mat that is electrically
grounded.
61200305L2-1B © 2004 ADTRAN, Inc.
or
ADMIN CRAFT
or
ADMIN
327