ADTRAN Atlas 550 System Manual page 290

Section 4 User Interface Guide
D P (FXO) > N
IAL LAN
Write security: 3; Read security: 5
Determines how the ATLAS 550 switchboard uses FXO ports for call routing. The
be used for call load balancing among the available ports on the module.
N
ORMAL
C
IRCULAR
A
LIGNED
Example: The unit receives an incoming call on Port 3. The switchboard looks for an interface who has
matching accept criteria to the number it received. A match is found on interface "Z" that has
set to
S A
ELECTION LIGNED
matching interfaces have
available, then a busy or fast busy will be returned to the calling party.
D P (O
IAL LAN CTAL
D P (E&M) > U
IAL LAN
Write security: 3; Read security: 5
This menu allows the user to define option parameters for ports which emulate an analog E&M connection
from the Network (PSTN).
D P (E&M) > U
IAL LAN
Write security: 3; Read security: 5
Specifies the configuration parameters for the endpoint.
D P (E&M) > U
IAL LAN
Write security: 3; Read security: 5
Indicates which ports of the Quad/Octal E&M Option Modules have been defined in this switched
endpoint (indicated by "! "), in another switched endpoint (indicated by "s"), or in a
(indicated by "n"). This field is read-only. The following characters may display in this field:
0-9 This port is available.
* This port is requesting this port for this connection, but the port is not yet activated.
! This port is used by this endpoint.
This port is used elsewhere in the switched D
S
S This port is in the switched dial plan and conflicts with this endpoint.
This port is used in one or more D
N
N This port is in one or more D
• This port is the wrong kind of port for this endpoint.
290
T > I
ETWORK ERM FCE
Always start with the lowest numbered available port (i.e., for a Quad FXO
Module with four configured interfaces, Port 1 would always be used first if
available).
Contiguous ports from last to first.
Provides the ability to maintain alignment between ports as if they were in
dedicated map mode. This scenario requires
both interfaces (usually on User Term and on Net Term). An interface that has
set to
P S
ORT ELECTION
the same port that the incoming call was received.
. This causes interface "Z" to only process the call if it has Port 3 available. If all
set to
P S
ORT ELECTION
E&M M )
ODULE
T
SER ERM
T > I
SER ERM FCE
T > I
SER ERM FCE
EDICATED
© 2004 ADTRAN, Inc.
C > P
ONFIG ORT
P
ORT
will only process a call from the switchboard on
A
LIGNED
and none of those interfaces have Port 3
A
LIGNED
C
ONFIG
C > P A
ONFIG ORTS VAILABLE
P
IAL LAN
M .
EDICATED APS
M , and conflicts with this endpoint.
APS
ATLAS 550 System Manual
S
ELECTION
method can
C
IRCULAR
set to
S A
ELECTION LIGNED
D
EDICATED
.
61200305L2-1B
on
P
ORT
M
AP