Check Points Of Every 200 Hours - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM

[5] CHECK POINTS OF EVERY 200 HOURS

Replacing Transmission Oil Filter (HST)
• See page G-22.
Adjusting Toe-in
1. Park the tractor on the flat place.
2. Turn steering wheel so front wheels are in the straight ahead
position.
3. Lower the implement, lock the parking brake and stop the
engine.
4. Measure distance between tire beads at front of tire, hub height.
5. Measure distance between tire beads at rear of tire, hub height.
6. Front distance should be shorter than rear distance. If not,
adjust tie rod length.
Toe-in (A - B) Factory specification
 Adjusting procedures
1. Loosen the tie-rod nut (1).
2. Turn the tie-rod joint (2) to adjust the tie-rod length until the
proper toe-in measurement is obtained.
3. Retighten the tie-rod nut (1).
Tightening torque Tie-rod lock nut
IMPORTANT
• A right and left tie-rod joint is adjusted to the same length.
(1) Tie-rod Nut
(2) Tie-rod Joint
Adjusting Air Conditioner Belt Tension (Cabin Type)
CAUTION
• Be sure to stop the engine before checking belt tension.
1. Stop the engine and remove the key.
2. Apply moderate thumb pressure to belt between pulleys.
3. If tension is incorrect, loosen the tension pulley mounting nut
and turn the adjusting bolt to adjust the belt tension within
acceptable limits.
4. Replace air-conditioner belt if it is damaged.
Proper air conditioner belt tension
(1) Adjusting Bolt
(2) Tension Pulley Mounting Nut
G-29
GENERAL
9Y1210824GEG0044US0
2 to 8 mm
0.079 to 0.315 in.
166.7 to 196.1 N·m
17.0 to 20.0 kgf·m
123 to 145 lbf·ft
(A) Wheel to Wheel Distance at rear
(B) Wheel to Wheel Distance at front
(C) Front
9Y1210824GEG0045US0
A deflection of between 10 to 12 mm
(0.4 to 0.48 in.) when the belt is
pressed (98 N [10 kgf, 22.1 lbf]) in the
middle of the span.
A: Check the belt tension
9Y1210824GEG0050US0
KiSC issued 03, 2016 A