Check Points Of Every 200 Hours - Kubota M108S Workshop Manual

M108S, WSM

[5] CHECK POINTS OF EVERY 200 HOURS

Changing Hydraulic Oil Filter
1. Refer to "[2] CHECK POINTS OF INITIAL 50 HOURS" in this
section.
Checking Radiator Hose and Hose Clamp
Check to see if radiator hoses are properly fixed every 200 hours
of operation or six months, whichever comes first.
1. If hose clamps are loose or water leaks, tighten bands securely.
2. Replace hoses and tighten hose clamps securely, if radiator
hoses are swollen, hardened or cracked. Replace hoses and
hose clamps every 2 years or earlier if checked and found that
hoses are swollen, hardened or cracked.
Precaution at Overheating
Take the following actions in the event the coolant temperature
be nearly or more than the boiling point, what is called
"Overheating".
1. Stop the machine operation in a safe place and keep the engine
unloaded idling.
2. Don't stop the engine suddenly, but stop it after about 5 minutes
of unloaded idling.
3. Keep yourself well away from the machine for further 10 minutes
or while the steam blown out.
4. Checking that there gets no danger such as burn, get rid of the
causes of overheating
"Troubleshooting" section, and then, start again the engine.
(1) Radiator Hose
Checking Power Steering Oil Line
1. Check to see that all line and hose clamps are tight and not
damaged.
2. If hoses and clamps are found worn or damaged, replace or
repair them at once.
(1) Power Steering Hose
Checking Oil Cooler Line
1. Check to see that all lines and hose clamps are tight and not
damaged.
2. If hoses and clamps are found worn or damaged, replace or
repair them at once.
(1) Oil Cooler
G-25
G GENERAL
according to the manual, see
(2) Clamp
(2) Oil Cooler Line
KiSC issued 06, 2007 A
W1046442
W1046500
W1046795
W1037652