Parked Regeneration Switch - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM

(13) Parked Regeneration Switch

NOTE
• Firstly check the connector voltage, secondly check the other wires continuity, then finally check the
switch continuity.
Connector Voltage
1. Disconnect the connector, and turn the main key switch "ON"
position.
2. Measure the voltage with a voltmeter across the terminals
shown in the table below.
3. If the reference value is not indicated as shown in the table
below, check the relating electric circuit.
Main switch at
Voltage
"ON"
(1) Parked Regeneration Switch
Switch Continuity
1. Check the continuity across the terminals shown in the table
below.
2. If the continuity specified below is not indicated, the parked
regeneration switch is faulty.
Terminal 1 – 4
Continuity Check
Terminal 3 – 6
(1) Connector (Switch Side)
9-S87
ELECTRICAL SYSTEM
9Y1210824ELS0127US0
Terminal 1 –
chassis
Approx. battery
voltage
Terminal 3 –
chassis
(2) Connector (Harness Side)
9Y1210824ELS0128US0
Continuity
9Y1210824ELS0129US0
KiSC issued 03, 2016 A