Check Points Of Every 200 Hours - Kubota B1220 Workshop Manual

B1220, B1620, B1820, WSM

[5] CHECK POINTS OF EVERY 200 HOURS

Changing Engine Oil
• See page G-18.
Replacing Engine Oil Filter
• See page G-18.
Checking Intake Air Line
1. Check to see that hoses and hose clamps are tight and not
damaged.
2. If hoses and clamps are found worn or damaged, replace or
repair them at once.
(1) Hose
Checking Radiator Hose and Hose Clamp
Check to see if radiator hoses are properly fixed every 200
hours of operation or six months, whichever comes first.
1. If hose clamps are loose or water leaks, tighten bands securely.
2. Replace hoses and tighten hose clamps securely, if radiator
hoses are swollen, hardened or cracked. Replace hoses and
hose clamps every 2 years or earlier if checked and found that
hoses are swollen, hardened or cracked.
Precaution at Overheating
Take the following actions in the event the coolant temperature
be nearly or more than the boiling point, what is called
"Overheating".
1. Stop the machine operation in a safe place and keep the engine
unloaded idling.
2. Do not stop the engine suddenly, but stop it after about
5 minutes of unloaded idling.
3. Keep yourself well away from the machine for further
10 minutes or while the steam blown out.
4. Checking that there gets on danger such as burn, get rid of the
causes of overheating according to the manual, see
"Troubleshooting" section, and then, start again the engine.
(1) Clamp
G-29
GENERAL
9Y1210272GEG0023US0
9Y1210272GEG0024US0
(2) Hose Clamp
9Y1210272GEG0025US0
(2) Radiator Hose
9Y1210272GEG0022US0
KiSC issued 07, 2011 A
(EU)