Cylinder Head And Valves - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM

[5] CYLINDER HEAD AND VALVES

Boost Sensor
IMPORTANT
• Be careful not to damage the sensor when removing the
boost sensor.
1. Remove the boost sensor mounting screw (1).
2. Remove the boost sensor (2).
(When reassembling)
• Replace the O-ring with new ones.
Boost sensor mounting
Tightening torque
screw
(1) Boost Sensor Mounting Screw
Cylinder Head Cover and Glow Plug
1. Remove the glow lead and the glow plugs (1).
2. Remove the cylinder head cover (2).
(When reassembling)
• Check to see that the cylinder head cover gasket is not
detective.
• Tighten the head cover mounting screws to specified torque.
• Replace the gasket of cylinder head cover with a new one.
• Adjust the direction of the ditch to the terminal side when the
seal (3) is installed in the glow plug (1).
• After installing the glow plug (1), make sure that the seal (3) was
set to the specified position.
Cylinder head cover screw
Tightening torque Glow lead mounting nut
Glow plug
(1) Glow Plug
(2) Cylinder Head Cover
(3) Seal
1-S56
ENGINE
0.98 to 1.7 N·m
0.10 to 0.18 kgf·m
0.73 to 1.3 lbf·ft
(2) Boost Sensor
9Y1210824ENS0037US0
6.86 to 11.3 N·m
0.700 to 1.15 kgf·m
5.06 to 8.33 lbf·ft
0.98 to 1.7 N·m
0.10 to 0.18 kgf·m
0.73 to 1.3 lbf·ft
15 to 19 N·m
1.5 to 2.0 kgf·m
11 to 14 lbf·ft
(A) Good
(B) Bad
9Y1210824ENS0038US0
KiSC issued 03, 2016 A