Kubota WSM L3560 Workshop Manual page 400

L3560, L4060, L4760, L5060, L5460, L6060, WSM
23T (24T) Gear Shaft and 27T (26T) Gear
1. Remove the 23T (24T) gear shaft (1).
2. Remove the external snap ring (3) and 27T (26T) gear (2).
(When reassembling)
• Install the oil seal (4) on the 18T gear shaft (6), noting the
direction of the oil seal (4) as shown in the figure.
• Direct the boss side of the gear (2) to the bearing side.
• Apply small amount of the grease to the oil seal (4), (5).
(1) 23T Gear Shaft
(L3560, L4060, L4760)
24T Gear Shaft (L5060)
(2) 27T Gear
(L3560, L4060, L4760)
26T Gear (L5060)
Clutch Housing Bearing Holder
1. Remove the three interlock balls (2) after removing the stopper
screw (1).
2. Pull out the clutch housing bearing holder (4) with using two jack
bolts (3).
(When reassembling)
• Tap in the clutch housing bearing holder (4) with plastic hammer
until contact to clutch housing case, and then tighten the screws
to specified torque.
• Install the three interlock balls (2) with a small amount of grease
to the clutch housing bearing holder (4) after setting the shift
forks and shift rods to the neutral position.
Clutch housing bearing
holder mounting screw
Tightening torque
Stopper screw
(1) Stopper Screw
(2) Interlock Ball
3-S81
TRANSMISSION
(3) External Snap Ring
(4) Oil Seal
(5) Oil Seal
(6) 18T Gear Shaft
9Y1210824TRS0056US0
48 to 55 N·m
4.9 to 5.7 kgf·m
36 to 41 lbf·ft
35 to 44 N·m
3.5 to 4.5 kgf·m
26 to 32 lbf·ft
(3) Jack Bolt
(4) Clutch Housing Bearing Holder
9Y1210824TRS0057US0
KiSC issued 03, 2016 A