Warning Lamps - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM

[9] WARNING LAMPS

Engine Oil Pressure Switch, Panel Board and Wiring Harness
1. Disconnect the lead (2) from the engine oil pressure switch after
turning the main switch "OFF".
2. Turn the main switch "ON" and connect a jumper lead from the
lead to the chassis.
3. If the engine oil pressure indicator lamp does not light, the panel
circuit or the wiring harness is faulty.
(1) Engine Oil Pressure Switch
(2) Switch Lead
Engine Oil Pressure Switch Continuity
1. Measure the resistance across the switch terminal and the
chassis.
2. If 0 ohm is not indicated in the normal state, the switch is faulty.
3. If infinity is not indicated at pressure over 50 kPa (0.5 kgf/cm
7 psi), the switch is faulty.
In normal state
Resistance
At pressure over
(Switch terminal –
approx. 50 kPa
Chassis)
(0.5 kgf/cm
(1) Engine Oil Pressure Switch
Charging Circuit (Panel Board and Wiring Harness)
1. Disconnect the 2P connector (2) from the alternator after turning
the main switch "OFF".
2. Turn the main switch "ON" and connect a jumper lead from the
wiring harness connector terminal (WR) to the chassis.
3. If the charge lamp does not light, the panel board circuit,
alternator, wiring harness, or fuse is fault.
(1) Alternator
(2) 2P Connector
9-S72
ELECTRICAL SYSTEM
(a) From Oil Pressure Lamp
9Y1210824ELS0092US0
0 Ω
Infinity
2
, 7 psi)
9Y1210824ELS0093US0
(a) From Charge Lamp
9Y1210824ELS0094US0
2
,
KiSC issued 03, 2016 A