Check Points Of Every 150 Hours; Check Points Of Every 200 Hours - Kubota ZD221-48 Workshop Manual

ZD221, WSM G GENERAL
[6] CHECK POINTS OF EVERY 150 HOURS
3GZAAAKOP019A
Changing Mower Gear Box Oil
A
CAUTION
• Be sure to stop the engine and remove the ley before
changing the oil.
1. To drain the used oil, remove the drain plug (1) and the oil filter
plug (3) at the gear box and drain the oil completely into the oil
pan.
2. After draining reinstall the drain plug (1).
3. Remove the oil level check plug (2).
4. Fill with the new oil up to the check plug port. (See
"LUBRICANTS AND FUEL" in this section.)
5. After filling reinstall the check plug (2) and the filler plugs (3).
(1) Drain Plug (Bolt)
(2) Check Plug (Bolt)
(3) Oil Filter Plug
W1036280
[7] CHECK POINTS OF EVERY 200 HOURS
3GZAAAKOPO 1 OA
A
B
Changing Engine Oil
A
CAUTION
• Be sure to stop the engine before changing oil.
1. Start and warm up the engine for approx. 5 minutes.
2. Place an oil pan underneath the engine.
3. To change the used oil, remove the drain plug (1) at the bottom
of the engine and drain the oil completely.
4. Screw in the drain plug (1).
5. Fill with the new oil up to upper line on the dipstick (3).
• IMPORTANT
• When using oil of different manufacture or viscosity from
the previous one, remove all of the old oil.
• Never mix two different type of oil.
• Use the proper SAE engine oil according to ambient
temperatures.
Refer to "LUBRICANTS, FUEL AND COOLANT",
(See page G-7.)
Engine oil capacity
(1) Drain Plug
(2) Oil Inlet Plug
(3) Dipstick
G-34
3.5 L
3.70 U.S.qts
3.08 Imp.qts
A: Upper Level
B: Lower Level
W1054834