Rear Wheel - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM
NOTE
• IND: for industrial

(2) Rear Wheel

NOTE
• Wheels with beveled or tapered holes: Use the tapered side
of lug nut.
Models
7-16, 7.2-16
Tire
Farm
1115 mm
Tread
(45.5 in.)
Models
8-16, 8.3-16
Tire
Farm
1155 mm
Tread
(45.5 in.)
Models
8-16, 8.3-16
Tire
Farm
1300 mm
Tread
(51.2 in.)
Models
9.5-16
Tire
Farm
1340 mm
Tread
(52.8 in.)
Rear Wheels
Rear tread width can be adjusted as shown with the standard
equipped tires.
To change the tread width
1. Remove the wheel rim and / or disk mounting bolts.
2. Change the position of the rim and / or disk (right and left) to the
desired position, and tighten the bolts.
IMPORTANT
• Always attach wheels as shown in the drawings.
• If not attached as illustrated, transmission parts may be
damaged.
• When re-fitting or adjusting a wheel, tighten the bolts to the
following torques then recheck after driving the tractor 200
m (200 yards) and 10 times of shuttle movement by 5 m (5
yards), and thereafter according to service interval. (See
page G-24.)
Tightening torque
(1) Rear Wheel Mounting Screws and
Nut
L3560
27 × 8.50-15 27 × 10.50-15
Turf Turf
1200 mm 1230 mm
(47.2 in.) (48.4 in.)
L4060
27 × 8.50-15 27 × 10.50-15
Turf Turf
1200 mm 1230 mm
(47.2 in.) (48.4 in.)
L4760
27 × 10.50-15 29 × 12.50-15
Turf Turf
1375 mm 1425 mm
(54.1 in.) (56.1 in.)
L5060, L5460, L6060
27 × 10.50-15 29 × 12.50-15
Turf Turf
1375 mm 1425 mm
(54.1 in.) (56.1 in.)
Rear wheel mounting
screws and nut
G-75
GENERAL
29 × 12.50-15 10-16.5
Turf IND
1170 mm 1195 mm
(46.1 in.) (47.0 in.)
29 × 12.50-15 10-16.5
Turf IND
1170 mm 1195 mm
(46.1 in.) (47.0 in.)
305R343 10-16.5
Turf IND
1455 mm 1340 mm
(57.3 in.) (52.8 in.)
305R343 10-16.5
Turf IND
1455 mm 1340 mm
(57.3 in.) (52.8 in.)
9Y1210824GEG0121US0
215 N·m
22 kgf·m
160 lbf·ft
9Y1210824GEG0122US0
KiSC issued 03, 2016 A