Checking Sensor And Switch For Hst - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM

(8) Checking Sensor and Switch for HST

Traveling Speed Sensor
1. Measure the resistance between terminal 7 of main ECU
connector B and terminal 2 of sensor connector.
2. If 0 ohm is not indicated, the wiring harness is faulty.
NOTE
• It is not necessary to adjust any kind of mode.
Terminal 2 of sensor
connector – Terminal 7
of main ECU
Resistance
connector B
Terminal 3 of sensor
connector – Chassis
(1) Traveling Speed Sensor
(2) Terminal 1
(3) Terminal 2
(4) Terminal 3
H-DS Lever Continuity
1. Remove the panel cover and steering post cover.
2. Disconnect the connector (2).
3. Measure the resistance between connector terminals, referring
to the table below.
4. If the measurement does not between as table, switch is faulty.
NOTE
• It is not necessary to adjust any kind of mode.
(1) H-DS Lever
(2) H-DS Connector
(3) Terminal a
(4) Terminal b
(5) Terminal c
9-S53
ELECTRICAL SYSTEM
0 Ω
A : Connector of Wire Harness Side
B : Main ECU Connector B (34P) of
Wire Harness Side
9Y1210824ELS0042US0
A: Connector of H-DS Lever Side
9Y1210824ELS0048US0
KiSC issued 03, 2016 A