Kubota WSM L3560 Workshop Manual page 398

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Shuttle Shift Arm and GST Valve Assembly
1. Remove the shuttle shift arm stopper screw, and then pull the
shuttle shift shaft (1) with shuttle shift arm (3) up.
2. Remove the GST valve (2) using two jack bolts.
3. Remove the shift pins (5) (6).
NOTE
• Do not fall down the shift pin while disassembling.
(When reassembling)
• When reassembling the shuttle shift arm (3) to the shuttle fork
rod (4), be sure to install it to the groove "A".
• Place the 1-2 shift pin (5) and the 3-4 shift pin (6) at neutral
position, main range shift pin (8) at L position (forward) and
sub-range shift pin (9) at Hi position (rearward), and then
assemble the GST valve.
• Be sure to match the each shift pin and shift piston.
• Apply liquid gasket (Three Bond 1208C or equivalent) to joint
face of the GST valve assembly.
• Install the GST valve (2) by hand, and then tighten the screws.
Do not use the hummer.
• Replace the pipe (7) with a new one, if damaged.
Shift pin mounting screws
Tightening torque
GST valve mounting
screws
(1) Shuttle Shift Shaft
(2) GST Value
(3) Shuttle Shift Arm
(4) Shuttle Fork Rod
(5) 1-2 Shift Pin
(6) 3-4 Shift Pin
Release Hub and Clutch Lever
1. Draw out the clutch release hub (7) and the release bearing (5)
as a unit.
2. Remove the release fork setting screws (4) and fork keys (2).
3. Draw out the clutch lever (3) to remove the release fork (1).
(When reassembling)
• Make sure the direction of the release fork (1) is correct.
• Inject grease to the release hub (7).
• Be sure to set the snap pins (6).
Tightening torque Release fork setting screws
(1) Release Fork
(2) Fork Key
(3) Clutch Lever
(4) Setting Screw
3-S79
TRANSMISSION
13 to 14 N·m
1.3 to 1.5 kgf·m
9.4 to 10 lbf·ft
43 to 48 N·m
4.3 to 4.9 kgf·m
32 to 35 lbf·ft
(7) Pipe
(8) Main Range Shift Pin
(9) Sub-range Shift Pin
A: Fork Rod Groove
9Y1210824TRS0054US0
24 to 27 N·m
2.4 to 2.8 kgf·m
18 to 20 lbf·ft
(5) Release Bearing
(6) Snap Pin
(7) Release Hub
9Y1210824TRS0012US0
KiSC issued 03, 2016 A