Kubota WSM L3560 Workshop Manual page 428

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Shaft Case, Input Shaft, Motor Shaft and Gear
1. Remove the shaft case mounting screws.
2. Screw down the M6 jack bolt (3) into the shaft case (1) and pull
it out.
3. Remove the shaft case (1).
4. Remove the 22T (23T, 26T) gear shaft (2).
5. Remove the 28T (27T, 24T) gear (4).
(When reassembling)
• Be sure to install the gasket (5).
(When replacing oil seal in shaft case)
• Install the oil seal (7) as shown in the figure, noting its direction.
• Apply grease to the oil seal (7).
• Replace the gasket (5) with a new one.
Tightening torque Shaft case mounting bolt
(1) Shaft Case
(2) 22T Gear Shaft (L3560)
23T Gear Shaft (L4060, L4760)
26T Gear Shaft (L5460, L6060)
(3) M6 Jack Bolt
3-S109
TRANSMISSION
24 to 28 N·m
2.5 to 2.8 kgf·m
18 to 20 lbf·ft
(4) 28T Gear (L3560)
27T Gear (L4060, L4760)
24T Gear (L5460, L6060)
(5) Gasket
(6) Motor Shaft
(7) Oil Seal
9Y1210824TRS0108US0
KiSC issued 03, 2016 A