Kubota WSM L3560 Workshop Manual page 399

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Separating Clutch Housing and Mid Case
1. Remove the clutch housing and mid case mounting screws and
nuts.
2. Separate the clutch housing (1) and mid case (2).
(When reassembling)
• Apply liquid gasket (Three Bond 1208C or equivalent) to joint
face of the clutch housing and mid case.
• Make sure to apply liquid gasket to elongated grooves (3) on the
mid case face and to those on the lower side of the clutch
housing face.
Clutch housing and mid
case mounting nut
Tightening torque
Clutch housing and mid
case mounting screw
(1) Clutch Housing
(2) Mid Case
Shaft Case
1. Remove the shaft case mounting screws.
2. Screw down the two M6 jack bolts (1) into the shaft case (2) and
pull it out.
3. Remove the shaft case (2).
(When reassembling)
• Apply liquid gasket (Three Bond 1208C or equivalent) to joint
face of the shaft case and clutch housing.
(When replacing oil seal in shaft case)
• Install the oil seal (3) as shown in the figure, noting its direction.
• Apply grease to the oil seal (3).
(1) M6 Jack Bolt
(2) Shaft Case
3-S80
TRANSMISSION
103 to 117 N·m
10.5 to 12.0 kgf·m
76.0 to 86.7 lbf·ft
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
(3) Elongated Groove
9Y1210824TRS0055US0
(3) Oil Seal
9Y1210824TRS0015US0
KiSC issued 03, 2016 A