Check Points Of Every 200 Hours - Kubota B2301 Workshop Manual

B2301, B2601, WSM

[4] CHECK POINTS OF EVERY 200 HOURS

Adjusting Brake Pedal
WARNING
To avoid personal injury or death:
• Stop the engine and chock the wheels before checking
brake pedal.
1. Release the parking brake.
2. Slightly depress the right and left brake pedals and measure
free travel at the top of pedal stroke.
3. If adjustment is needed, turn the lock nut and adjust nut, adjust
free travel.
4. Retighten the lock nut.
Proper brake pedal free travel
(1) Lock Nut (Both Sides)
(2) Turnbuckle (Both Sides)
Checking Fuel Line
1. Check to see that all line and hose clamps are tight and not
damaged.
2. If hoses and clamps are found worn or damaged, replace or
repair them at once.
NOTE
• If the fuel line is removed, be sure to properly bleed the fuel
system.
(1) Fuel Hoses
Replacing Engine Oil Filter
WARNING
To avoid personal injury or death:
• Be sure to stop the engine before changing the oil filter
cartridge.
• Allow engine to cool down sufficiently, oil can be hot and
can burn.
1. Remove the oil filter.
2. Put a film of clean engine oil on the rubber seal of the new filter.
3. Tighten the filter quickly until it contacts the mounting surface.
Tighten filter by hand an additional 1/2 turn only.
4. After the new filter has been replaced, the engine oil normally
decreases a little. Make sure that the engine oil does not leak
through the seal and be sure to check the oil level on the
dipstick. Then, replenish the engine oil up to the prescribed
level.
IMPORTANT
• To prevent serious damage to the engine, use only a
KUBOTA genuine filter.
(1) Engine Oil Filter
G-25
GENERAL
30 to 40 mm (1.2 to 1.5 in.) on the
pedal
Keep the free travel in the right and left
brake pedals equal.
A: Free Travel
9Y1211156GEG0028US0
(2) Hose Clamps
9Y1211156GEG0029US0
9Y1211156GEG0030US0
KiSC issued 11, 2014 A