Kubota WSM L3560 Workshop Manual page 46

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Checking Water Separator
1. As water is collected in the water separator, the red float is
raised.
2. When the red float has reached the white line, close the fuel
valve, loosen the retainer ring, take out the cup, and clean the
cup. Be careful not to break the element.
3. Place the cup back into position. Bleed the fuel system.
IMPORTANT
• If water is drawn through to the fuel pump, extensive
damage will occur.
(1) Red Float
(2) Fuel Valve
(3) Retainer Ring
(4) Cup
Checking Engine Oil Level
CAUTION
• Be sure to stop the engine before checking the oil level.
1. Park the machine on a flat surface.
2. Check engine oil before starting the engine or 5 minutes or more
after the engine has stopped.
3. To check the oil level, draw out the dipstick, wipe it clean,
replace it, and draw it out again. Check to see that the oil level
lies between the two notches.
If the level is too low, add new oil to the prescribed level at the
oil inlet. (Refer to "4. LUBRICANTS, FUEL AND COOLANT" on
page G-9.)
IMPORTANT
• When using an oil of different maker or viscosity from the
previous one, remove all of the old oil.
Never mix two different types of oil.
• If oil level is low, do not run engine.
(1) Oil Inlet
(2) Dipstick
Checking Transmission Fluid Level
1. Park the machine on a flat surface, lower the implement and
shut off engine.
2. To check the oil level, draw out the dipstick, wipe it clean,
replace it, and draw it out again. Check to see that the oil level
lies between the two notches.
If the level is too low, add new oil to the prescribed level at the
oil inlet. (Refer to"4. LUBRICANTS, FUEL AND COOLANT" on
page G-9.)
IMPORTANT
• If oil level is low, do not run engine.
(1) Gauge
(2) Oil Inlet
G-17
GENERAL
A : WHITE LINE
9Y1210824GEG0012US0
A: Oil level is acceptable within this
range.
9Y1210824GEG0013US0
A: Oil level is acceptable within this
range.
9Y1210824GEG0014US0
KiSC issued 03, 2016 A