Kubota WSM L3560 Workshop Manual page 416

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Disassembling Regulating Valve
NOTE
• The regulating valve has been precisely machined and
assembled. It is advisable not to disassemble it as long as
there is no necessary.
1. Remove the plate (8), reducing spool (11), spring retainer (5)
and spring (10).
2. Separate the regulating valve case (12) and support (4).
3. Remove the bush (6) and poppet (7).
4. Remove the joint bolt (14).
5. Remove the spring (13) and the poppet (9).
6. Remove the spring retainer (5) and spring (10).
(When reassembling)
• Be careful not to damage the O-rings.
IMPORTANT
• After reassembling, the adjustment of regulating pressure
should be performed.
Joint bolt (14)
Tightening torque Plate (8)
Regulating valve case and
support mounting screws
(1) Nut
(2) Adjustor
(3) Washer with Rubber
(4) Support
(5) Spring Retainer
(6) Bush
(7) Poppet
3-S97
TRANSMISSION
35 to 39 N·m
3.5 to 4.0 kgf·m
26 to 28 lbf·ft
9.8 N·m
1.0 kgf·m
7.2 lbf·ft
9.8 N·m
1.0 kgf·m
7.2 lbf·ft
(8) Plate
(9) Poppet
(10) Spring
(11) Reducing Spool
(12) Regulating Valve Case
(13) Spring
(14) Joint Bolt
9Y1210824TRS0081US0
KiSC issued 03, 2016 A