Kubota WSM L3560 Workshop Manual page 693

L3560, L4060, L4760, L5060, L5460, L6060, WSM
HST Pedal Sensor, Hand Throttle Sensor and Swashplate
Sensor
1. Measure the resistance between terminal c (7) and GND (8).
2. Measure the resistance between terminal GND (8) and a while
slowly turning the sensor shaft.
3. Measure the resistance terminal GND (8) and b (6) while slowly
turning the sensor shaft.
4. It is OK if the resistance value approximates to the value shown
in the table below.
NOTE
• When replacing the each sensor be sure to adjust the mode
"K" and "L".
(Reference)
• The change of resistance can be checking easily when an
analog tester is employed.
Terminal c – Terminal GND
Terminal GND – Terminal a
Reference
Terminal GND – Terminal b
(1) HST Pedal Sensor
(2) Hand Throttle Lever Sensor
(3) Swashplate Position Sensor
(4) Sensor Shaft
9-S55
ELECTRICAL SYSTEM
Approx. 1 kΩ
Resistance is normal if
smoothly changing
Approx. 1 kΩ to 0 Ω
Resistance is normal if
smoothly changing
Approx. 0 Ω to 1 kΩ
(5) Terminal a
(6) Terminal b
(7) Terminal c
(8) Terminal GND
9Y1210824ELS0050US0
KiSC issued 03, 2016 A