Testing, Setting And Adjusting Function; Glow Control - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM

(3) Testing, Setting and adjusting Function

Mode Details of Mode
Test Mode
A
Traveling Speed Coefficient Input Mode
B
PTO Coefficient Number Input Mode
C
Error Information Reset Mode
D
GST Lever Sensor Fine-adjustment Mode
E
GST Valve Fine-adjustment Mode
F
GST Shift shock Fine-adjustment Mode
G
Speed Unit Input Mode
J
HST Pedal, Range Shift Lever,
K
Fine-adjustment Mode
Throttle Sensor Fine-adjustment Mode
L
Mode for Factory
M
Tractor Model Select Mode
N

(4) Glow Control

The electronic meter incorporates the glow control which was external single parts so for, and controls it with CPU.
When the main switch is turned "ON", the temperature of the coolant is detected with the coolant temperature
sensor, and the time to supply current to the glow plug and the glow indicator lamp is controlled by CPU according to
the detected temperature. And the supply current to the glow plug is stopped automatically when the preheating time
is completed, and indicator lamp on the electronic meter panel is turned off.
It can do various settings, adjustments and testing by
using the Liquid Crystal Display (LCD) (1).
When the main switch is turned to "ON" or "START"
position while holding down the display mode switch (2),
the service inspect display as shown in figure is
indicated. And then, a target mode is selected, the data
input and the fine adjustment, etc. can be done.
The following table shows the content of each mode
display by the alphabet.
(1) Liquid Crystal Display (LCD) (2) Display Mode Switch
Transmission Model
Manual GST HST
  
  
  
  



  

  

  
9-M42
ELECTRICAL SYSTEM
Contents
For the checking the sensors voltage or engine and
PTO revolution exhaust gas temperature is required
For Inputting the operation coefficient of traveling
speed to Intellipanel.
For Inputting the operation coefficient number of
PTO to Intellipanel.
For deleting the error information.
For setting the Neutral position of GST lever sensor
(Input the sensor information to ECU)
For setting the function of proportional reducing
valve (Input the valve information to ECU).
For adjusting the clutch engaging interval.
For inputting the unit of traveling speeds to
Intellipanel.
For setting the each sensors position (Input the
sensor information to ECU).
For setting the throttle sensor (Input the sensor
information to ECU).
Contact your KUBOTA distributor.
For inputting the model of tractor ECU.
9Y1210824ELM0068US0
9Y1210824ELM0069US0
KiSC issued 03, 2016 A