Kubota WSM L3560 Workshop Manual page 411

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Separating Mid Case and Transmission Case
1. Separate the mid case and transmission case after removing
their mounting screws and nut.
(When reassembling)
• Make sure to insert the PTO shaft to PTO clutch firmly, turning
the PTO shaft.
• Make sure to insert the front wheel drive shaft to coupling firmly.
• Apply liquid gasket (Three Bond 1208C or equivalent) to joint
face of the mid case and transmission case.
Mid case and transmission
case mounting screw
Tightening torque
Mid case and transmission
case mounting nut
Pinion Bearing Cover
1. Remove the stake of lock nut (5).
2. Lock the turning of spiral bevel pinion and remove the lock nut
(5).
3. Remove the pinion bearing case mounting screws.
4. Remove the pinion bearing cover (4) and shims (1).
(When reassembling)
• Make sure of the number of shims in the pinion bearing case.
• Replace the lock nut (5) with a new one, and stake the lock nut
firmly after installing the parts on the shaft.
Lock nut
Tightening torque
Pinion bearing case
mounting screw
(1) Shim
(2) Pinion Bearing Case
(3) Spiral Bevel Pinion Shaft
3-S92
TRANSMISSION
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
103 to 117 N·m
10.5 to 12.0 kgf·m
76.0 to 86.7 lbf·ft
9Y1210824TRS0074US0
150 to 190 N·m
15 to 20 kgf·m
110 to 140 lbf·ft
40 to 44 N·m
4.0 to 4.5 kgf·m
29 to 32 lbf·ft
(4) Pinion Bearing Cover
(5) Lock Nut
9Y1210824TRS0038US0
KiSC issued 03, 2016 A