Kubota WSM L3560 Workshop Manual page 198

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Propeller Shaft
1. Slide the propeller shaft cover (4) and (8) after removing the
screws (7).
2. Tap out the spring pins (2), (6) and slide the couplings (1), (5)
and then remove the propeller shaft with covers (4), (8).
(When reassembling)
• Apply grease to the splines of propeller shaft (3).
(1) Coupling
(2) Spring Pin
(3) Propeller Shaft
(4) Propeller Shaft Cover
Separating Engine from Clutch Housing and Front Axle Frame
1. Place the disassembling stands under the engine and clutch
housing.
2. Remove the engine and clutch housing mounting screws and
nuts.
3. Separate the engine and clutch housing.
4. [L3560]
Remove one of the two engine hooks attached on the left side
of the engine and install it on the right rear side of the engine.
[except L3560]
Install the engine hooks (1), (2). (See page G-61, G-62.)
5. Hold the engine by the hoist chain hooked on the engine hooks
(1) and (2).
6. Remove the engine mounting screws.
7. Lift up the engine to separate from the front axle frame (3).
(When reassembling)
• Apply grease to the spline of clutch shaft.
• Apply liquid gasket (Three Bond 1211 or equivalent) to joint face
of the flywheel housing and clutch housing.
Engine and clutch housing
mounting screw
Engine and clutch housing
mounting nut
Tightening torque
Front axle frame mounting
screw (7T)
Front axle frame mounting
screw (9T)
(1) Engine Hook
(2) Engine Hook
1-S51
ENGINE
(5) Coupling
(6) Spring Pin
(7) Screws
(8) Propeller Shaft Cover
9Y1210824FAS0009US0
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
103 to 117 N·m
10.5 to 12.0 kgf·m
76.0 to 86.7 lbf·ft
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
103 to 117 N·m
10.5 to 12.0 kgf·m
76.0 to 86.7 lbf·ft
(3) Front Axle Frame
9Y1210824ENS0027US0
KiSC issued 03, 2016 A