Steering Cylinder - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM

[3] STEERING CYLINDER

Front Wheel, Cylinder Cover and Tie-rod
1. Place a disassembly stand under the engine and support it with
a jack.
2. Remove the front wheel and cylinder cover (2).
3. Pull out the cotter pin and remove the tie-rod end slotted nut.
4. Disconnect the tie-rod (1).
(When reassembling)
• After tightening the tie-rod end slotted nut to the specified
torque, install a cotter pin as shown in the figure.
Front wheel mounting nut
Tightening torque
Tie-rod end
slotted nut
(1) Tie-rod
Steering Cylinder
1. Disconnect the power steering hoses (1), (3) and remove the
elbows.
2. Disconnect the tie-rod joint L.H. (4).
3. Remove the internal snap ring (2).
4. Remove the steering cylinder to the left.
5. Remove the head cover (7) and draw out the cylinder rod (6).
(When reassembling)
• Apply transmission fluid to the oil seal and O-ring.
• Apply liquid lock (Three Bond 1324B or equivalent) to the thread
of tie-rod joint (4).
Power steering hose
retaining nut
Tightening torque Tie-rod joint
Tie-rod joint lock nut
(1) Power Steering Hose R.H.
(2) Internal Snap Ring
(3) Power Steering Hose L.H.
(4) Tie-rod Joint
7-S7
STEERING
137 N·m
14.0 kgf·m
101 lbf·ft
40 to 45 N·m
L3560
4.0 to 4.6 kgf·m
L4060
29 to 33 lbf·ft
L4760
157 to 176 N·m
L5060
16.0 to 18.0 kgf·m
L5460
116 to 130 lbf·ft
L6060
(2) Cylinder Cover
9Y1210824STS0008US0
25 to 29 N·m
2.5 to 3.0 kgf·m
18 to 21 lbf·ft
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
(5) Lock Nut
(6) Cylinder Rod
(7) Head Cover
9Y1210824STS0009US0
KiSC issued 03, 2016 A