Thermostat - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM

[6] THERMOSTAT

Valves
1. Remove the valve caps (3).
2. Push the valve spring retainer with the valve spring replacer (1)
and remove the valve spring collets (4).
3. Remove the valve spring retainer (5) and valve spring (6).
4. Remove the valve (7).
(When reassembling)
• Clean the valve stem and the valve guide hole, and apply
engine oil sufficiently.
• After you install the valve spring collets (4), lightly tap the stem
tip to attach it correctly with the plastic hammer.
IMPORTANT
• Do not change the combination of valve and valve guide.
(1) Valve Spring Replacer
(2) Valve Stem Seal
(3) Valve Cap
(4) Valve Spring Collet
Thermostat Assembly
1. Remove the thermostat cover mounting screws, and remove
the thermostat cover (1).
2. Remove the thermostat assembly (3).
(When reassembling)
• Replace the thermostat cover gasket (2) with a new one.
• Apply a liquid gasket (Three Bond 1215 or equivalent) to the
water flange 1 (4) and flange 2 (5).
(1) Thermostat Cover
(2) Thermostat Cover Gasket
(3) Thermostat Assembly
Water Pump Assembly (If Necessary)
1. Remove the water pump assembly (1) from the gear case.
(When reassembling)
• Replace the gasket (2) with a new one.
(1) Water Pump Assembly
1-S61
ENGINE
(5) Valve Spring Retainer
(6) Valve Spring
(7) Valve
9Y1210824ENS0043US0
(4) Water Flange 1
(5) Water Flange 2
9Y1210824ENS0044US0
(2) Gasket
9Y1210824ENS0045US0
KiSC issued 03, 2016 A