Kubota WSM L3560 Workshop Manual page 768

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Recirculation / Fresh Air Selection Switch Checking
1. Use a circuit tester to check the recirculation / fresh air selection
switch.
2. Connect the 16P connector (1) and the 6P connector (2).
3. Switch off the recirculation / fresh air selection switch (3).
Touch the red (+) probe to the terminal 15 and the black (−)
probe to the terminal 12 as shown in the picture.
4. Switch on the main switch.
Switch on the recirculation / fresh air selection switch (3).
Make sure that the output voltage is the some with the battery
voltage.
5. Touch the black (−) probe to the terminal 14. Switch off the
recirculation / fresh air selection switch (3).
6. If the output voltage differs from the battery voltage, the
recirculation / fresh air selection is faulty.
(1) 16P Connector
(2) 6P Connector
(3) Recirculation / Fresh Air Selection
Switch
10-S25
(a) 16P Connector (Switch Side)
(b) 16P Connector (Wire Harness
Side)
9Y1210824CAS0055US0
KiSC issued 03, 2016 A
CABIN