Kubota WSM L3560 Workshop Manual page 76

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Replacing Head Lamp
NOTE
To avoid personal injury:
• Be careful not to drop the bulb, hit anything against the
lamp, apply excess force, and get the lamp scratched. If
broken, glass may cause injury. Pay more attention to
halogen lamps in particular, which have high pressure
inside.
• Before replacing the lamp, be sure to turn off the light and
wait until the bulb cools down, otherwise, you may get
burned.
 Side work light
1. While pushing the lock button, pull and remove the electrical
connector.
2. Turn the bulb counter-clockwise slightly and take out the bulb.
3. Replace with a new bulb and reinstall the side work light
assembly in the reverse order.
 Head lamp
1. While pushing the right and left lock buttons, pull and remove
the electrical connector.
2. Remove the rubber boot.
3. Remove the clamping fixture and take out the bulb.
4. Replace with a new bulb and reinstall the head lamp assembly
in the reverse order.
IMPORTANT
• Be sure to use a new bulb of the specified wattage.
• Never touch the bulb surface (glass) with bare hands.
Fingerprints, for example, may break the bulb.
(1) Electrical Connector
(2) Lock Button
(3) Rubber Boot
Lubricating Points
(1) Door Hinge
Adding Washer Liquid
1. Add a proper amount of automobile washer liquid.
Tank capacity
(1) Washer Liquid Tank
G-47
GENERAL
(4) Clamping Fixture
(5) Bulb (Side Work Light)
(6) Bulb (Head Lamp)
9Y1210824GEG0093US0
(2) Rear Window Hinge
9Y1210824GEG0094US0
2.0 L
2.1 U.S.qts
1.8 Imp.qts
9Y1210824GEG0095US0
KiSC issued 03, 2016 A