Preparation; Separating Clutch Housing From Engine (Rops Type) - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM

5. PREPARATION

[1] SEPARATING CLUTCH HOUSING FROM ENGINE (ROPS TYPE)

Draining the Transmission Fluid
CAUTION
• Allow the engine to cool down sufficiently, oil can be hot
and burn.
1. Place oil pans underneath the transmission case.
2. Remove the drain plugs (1).
3. Drain the transmission fluid completely.
4. Reinstall the drain plugs (1).
(When refilling)
• Fill up from filling port after removing the filling plug (2) until
reaching the upper notch on the dipstick (3).
• After running the engine for a few minutes, stop it and check the
oil level again, add the fluid to prescribed level if it is not correct
level.
L3560
Transmission fluid L4060
capacity L4760
L5060
L5460
L6060
IMPORTANT
• Use only KUBOTA SUPER UDT fluid. Use of other oils may
damage the transmission or hydraulic system. (Refer to "4.
LUBRICANTS, FUEL AND COOLANT" on page G-9.)
• Do not mix different brands of fluid together.
(1) Drain Plugs
(2) Filling Plug
(3) Dipstick
2-S5
CLUTCH
42 L
11.1 U.S.gals
9.24 Imp.gals
43 L
11.4 U.S.gals
9.5 Imp.gals
45 L
11.9 U.S.gals
9.90 Imp.gals
[A] Manual Transmission / GST
[B] HST
A: Oil level is acceptable within this
range.
9Y1210824CLS0005US0
KiSC issued 03, 2016 A