Kubota WSM L3560 Workshop Manual page 500

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Bevel Gear Case and Front Gear Case (L4760, L5060, L5460
and L6060)
1. Remove the bevel gear case mounting screws.
2. Remove the bevel gear case (3) and front gear case (4) as a unit
from the front axle case (1).
(When reassembling)
• Apply grease to the O-ring (2) and be careful not to damage it.
• Do not interchange right and left bevel gear case assemblies.
Bevel gear case mounting
Tightening torque
screw
(1) Front Axle Case
(2) O-ring
Axle Flange and Front Gear Case
1. Remove the axle flange mounting screws.
2. Remove the axle flange (1).
(When reassembling)
• Apply grease to the O-ring (2) of axle flange.
• Tighten the axle flange mounting screws and nuts diagonally in
several steps.
Axle flange
mounting
Tightening torque
screw and
nut
(1) Axle Flange
Bevel Gear and Bevel Gear Shaft
1. Remove the plug (5).
2. Remove the internal snap ring (4) and shim (3).
3. Tap out the bevel gear (2) with ball bearing.
4. Draw out the bevel gear shaft (1).
(1) Bevel Gear Shaft
(2) Bevel Gear
(3) Shim
6-S10
FRONT AXLE
167 to 196 N·m
17.0 to 20.0 kgf·m
123 to 144 lbf·ft
(3) Bevel Gear Case
(4) Front Gear Case
9Y1210824FAS0015US0
24 to 27 N·m
L3560
2.4 to 2.8 kgf·m
L4060
18 to 20 lbf·ft
L4760
30 to 34 N·m
L5060
3.0 to 3.5 kgf·m
L5460
22 to 25 lbf·ft
L6060
(2) O-ring
9Y1210824FAS0016US0
(4) Internal Snap Ring
(5) Plug
9Y1210824FAS0017US0
KiSC issued 03, 2016 A