Kubota WSM L3560 Workshop Manual page 483

L3560, L4060, L4760, L5060, L5460, L6060, WSM
Brake Case
1. Remove the PTO cover.
2. Remove the screw (1) and displace the hydraulic cylinder pin (2)
to drawbar side.
3. Disconnect the brake rod (3).
4. Place a block of wood (5) between floor seat (6) and lift arm
support to support the floor seat. [ROPS type]
5. Remove the hydraulic cylinder hose (4).
6. Remove the brake case (7).
(When reassembling)
• Place the brake discs (10) so that the hole "A" of brake discs
should be overlapped 50 % or more.
• Apply liquid gasket (Three Bond 1208C or equivalent) to joint
face of the brake case and differential gear case.
• Apply the liquid lock to the fulcrum screw.
• Be sure to apply the liquid gasket to "a" position.
• Apply grease to the steel ball seats. (Do not grease
excessively.)
• Be sure to fix the brake cam (13) and cam plate (9).
• Before installing the brake case to the transmission case, install
the cam plate (9) to the transmission case.
Brake case mounting screw
and nut
Floor seat mounting bolt
and nut
Tightening torque
Fulcrum screw (Manual
tranmission and GST)
Fulcrum screw (HST)
(1) Screw
(2) Hydraulic Cylinder Pin
(3) Brake Rod
(4) Hydraulic Cylinder Hose
(5) Block of Wood
(6) Floor Seat
(7) Brake Case
5-S13
BRAKES
78 to 90 N·m
7.9 to 9.2 kgf·m
58 to 66 lbf·ft
200 to 220 N·m
20 to 23 kgf·m
150 to 160 lbf·ft
40 to 44 N·m
4.0 to 4.5 kgf·m
29 to 32 lbf·ft
63 to 72 N·m
4.6 to 7.4 kgf·m
47 to 53 lbf·ft
(8) Steel Ball
(9) Cam Plate
(10) Brake Disc
(11) Plate
(12) Brake Shaft
(13) Brake Cam
9Y1210824BRS0010US0
KiSC issued 03, 2016 A