Removing Heater Hoses - Kubota WSM L3560 Workshop Manual

L3560, L4060, L4760, L5060, L5460, L6060, WSM

(5) Removing Heater Hoses

High Pressure and Low Pressure Pipes
1. Remove the outer roof.
2. Disconnect the high pressure pipe 2 (2), then cap the open
fitting immediately to keep moisture out of the system.
3. Remove the rubber and disconnect the low pressure pipe (1),
then cap the open fittings immediately to keep moisture out of
the system.
4. Remove the inner covers (3).
(When reassembling)
• Replace the rubber with a new one.
• Apply compressor oil (DENSO ND-OIL 8 or equivalent) to the
O-rings and be careful not to damage them.
High pressure pipe 2
retaining nut
Tightening torque
Low pressure pipe retaining
nut
(1) Low Pressure Pipe
(2) High Pressure Pipe 2
Front Grill, Skirt and Bonnet
• See page 10-S35.
Draining Coolant
• See page 10-S34.
Hose Clamp
1. Remove the hose bands (1).
2. Remove the hose clamp (2).
NOTE
• Before disconnecting the heater hoses (3), put the parting
marks on the hoses for making proper reconnecting.
3. Disconnect the heater hoses (3), then remove them from under
the cabin.
(When reassembling)
• Connecting the heater hoses at their original position.
(1) Hose Band
(2) Hose Clamps
10-S51
11.8 to 14.7 N·m
1.21 to 1.49 kgf·m
8.71 to 10.8 lbf·ft
7.90 to 11.8 N·m
0.806 to 1.20 kgf·m
5.83 to 8.70 lbf·ft
(3) Inner Cover
9Y1210824CAS0086US0
9Y1210824CAS0087US0
9Y1210824CAS0078US0
(3) Heater Hoses
9Y1210824CAS0088US0
KiSC issued 03, 2016 A
CABIN