Power Steering Cylinder - Kubota B1830 Workshop Manual

B1830,B2230,B2530,B3030, WSM

(3) Power Steering Cylinder

Steering Wheel, Meter Panel Bonnet and Fuel Tank
Refer to "TRANSMISSION" section.
Tie-rod End
1. Remove the slotted nut (4) and remove the tie-rod end (3).
2. Remove the front axle brackets (1), (2).
(When reassembling)
• Apply grease to the thrust collar of front axle bracket.
• Apply grease to the O-ring and take care not to damage it.
• After tightening the slotted nut, install cotter pin as shown in the
figure.
(Bleeding air in power steering circuit)
• Start the engine.
• Turn the steering wheel slowly in both directions all the way
alternately several times, and stop the engine.
Tie-rod slotted nut
Tightening torque
Tie-rod joint
(1) Front Axle Bracket (Front)
(2) Front Axle Bracket (Rear)
(3) Tie-rod End
7-S7
STEERING
9Y1210003STS0008US0
17.7 to 34.3 N·m
1.8 to 3.5 kgf·m
13.0 to 25.3 lbf·ft
74 to 84 N·m
7.5 to 8.6 kgf·m
54.4 to 61.9 lbf·ft
(4) Slotted Nut
(5) Cotter Pin
9Y1210003STS0009US0
KiSC issued 05, 2012 A