Canon imageRUNNER ADVANCE C5051 Series Service Manual page 400

4
Parts Replacement and Cleaning > Image Formation System > Removing the Hopper (Y) > Procedure
CAUTION:
When installing the Toner Tray, align the Rod Lever with the Toner Cover Open/Close
Rod Lever and install it.
Toner cover Open/Close rod lever
Rod lever
CAUTION:
When installing the removed Toner Container, be sure not to shake it.
CAUTION:
When the Main Drive Unit is removed simultaneously, make sure to install the Main
Drive Unit first and then, the Hopper Unit in order. Otherwise, toner supply failure may
occur.
■ Actions after Replacement
When replacing the Developing Assembly, make sure to initialize before installing the Toner
Container.
COPIER > FUNCTION > INSTALL > INISET-M
If install the Toner Container before initialization, T/D ratio cannot set the right value.
4 Parts Replacement and Cleaning > Image Formation System > Removing the Hopper (Y) > Procedure
F-4-242
Removing the Hopper (Y)
■ Preparations
1) Release the lock of Toner Container. (By service mode)
2) Open the Front Cover, the Right Lower Cover and Right Upper Cover.
3) Remove the ITB Unit.
4) Remove the Process Unit.
5) Remove the Color Drum Heater. (When the option is installed)
6) Remove the Toner Container Front Inner Cover.
■ Procedure
1) Remove the Toner Tray.
• 1 screw (M4 binding)
2) Remove the Left Cover.
• 5 rubber caps
• 5 screws
• 5 claws
Crows
x5
Crow
x5
Crows
4-134
F-4-243
F-4-244
4-134