Canon imageRUNNER ADVANCE C5051 Series Service Manual page 805

■ PASCAL
COPIER > ADJUST > PASCAL
OFST-P-Y Y density adj at test print reading
Lv.1 Details To adjust the offset of Y-color test print reading signal at auto gradation
adjustment (full adjustment).
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the value is larger, the image after adjustment gets darker.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Caution Do not use this at the normal service.
Display/adj/set range -128 to 128
Default value According to the setting at shipment
OFST-P-M M density adj at test print reading
Lv.1 Details To adjust the offset of M-color test print reading signal at auto
gradation adjustment (full adjustment).
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the value is larger, the image after adjustment gets darker.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -128 to 128
Default value According to the setting at shipment
OFST-P-C C density adj at test print reading
Lv.1 Details To adjust the offset of C-color test print reading signal at auto
gradation adjustment (full adjustment).
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the value is larger, the image after adjustment gets darker.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -128 to 128
Default value According to the setting at shipment
8
Service Mode > COPIER > ADJUST > PASCAL
8 Service Mode > COPIER > ADJUST > PASCAL
COPIER > ADJUST > PASCAL
OFST-P-K Bk density adj at test print reading
Lv.1 Details To adjust the offset of Bk-color test print reading signal at auto
gradation adjustment (full adjustment).
When replacing the Reader Controller PCB/clearing RAM data, enter
the value of service label.
As the value is larger, the image after adjustment gets darker.
Use case When replacing the Reader Controller PCB/clearing RAM data
Adj/set/operate method 1) Enter the setting value (switch negative/positive by -/+ key) and
press OK key.
2) Turn OFF/ON the main power switch.
Caution After the setting value is changed, write the changed value in the
service label.
Display/adj/set range -128 to 128
Default value According to the setting at shipment
8-105
T-8-26
8-105