Canon imageRUNNER ADVANCE C5051 Series Service Manual page 372

4
Parts Replacement and Cleaning > Image Formation System > Reinstalling the ITB > Procedure
6) Put the ITB under the Belt Retainer Sheet (on the left side of the figure), bring the ITB
Displacement Sensor Flag into contact with the ITB edge (at the center of the figure), and
then, align the marking line (on the right side of the figure) with the position of the ITB.
Belt Retainer Sheet
ITB Displacement sensor flag
CAUTION:
When installing the ITB, be sure that the Plastic Film on the ITB Unit is inside of the
ITB.
4 Parts Replacement and Cleaning > Image Formation System > Reinstalling the ITB > Procedure
7) Return the Secondary Transfer Inner Roller Unit to straight, and then install the pin
removed.
• 1 screw
Marking Line
8) Remove the ITB Unit from the ITB Cover and install it to the plate.
• 2 claws
F-4-156
x2
4-106
F-4-157
F-4-158
4-106