Canon imageRUNNER ADVANCE C5051 Series Service Manual page 360

4
Parts Replacement and Cleaning > Image Formation System > Installing the ITB Cleaning Blade Unit > Actions after Replacement
3) While paying attention not to bend the Protection Sheet, lift the sheet using a screwdriver.
After that, check that the sheet that is being lifted is above the pad.
4 Parts Replacement and Cleaning > Image Formation System > Installing the ITB Cleaning Blade Unit > Actions after Replacement
4) After installing the ITB Cleaning Unit to the ITB Unit, apply tospearl on the whole area
indicated in the figure below.
CAUTION:
When applying tospearl, be careful not to scatter it on inside of the ITB, the Drive Roller
and the Secondary Transfer Inner Roller.
If it is scattered on inside of the ITB, the Drive Roller or the Secondary Transfer Inner
Roller, wipe it with lint-free paper moistened with alcohol while rotating the motor by
hand. At this time, turn the motor counterclockwise and do not turn it clockwise.
■ Actions after Replacement
1) To execute the ITB Equilibrium Position Detection, make the main body in standby state.
F-4-127 2) Execute the ITB Equilibrium Position Detection Service Mode (COPIER>FUNCTION>MISC-
P>ITB-INIT) (Level 1). This service mode will take approx. 2 to 3 minutes.
4-94
F-4-128
4-94