Canon imageRUNNER ADVANCE C5051 Series Service Manual page 363

4
Parts Replacement and Cleaning > Image Formation System > Removing the ITB > Procedure
9) Insert papers as shown in the figure to prevent the ITB getting damage by the plate when
removing the ITB.
10) Hold the ITB within 10mm from the edge and remove it upward.
4 Parts Replacement and Cleaning > Image Formation System > Removing the ITB > Procedure
F-4-135
10mm
10mm
F-4-136
CAUTION:
Do not touch the surface of ITB Drive Roller, Secondary Transfer Inner Roller and
Primary Transfer Roller as it may cause the image failure.
CAUTION:
When replacing ITB with a new one, affix the label to the specific position near the
Waste Toner Ejection Mouth of the ITB Cleaning Unit after the ITB Unit is installed.
When affixing the new label, be sure to remove the old label and replace with the new
one on the same position.
4-97
4-97