Figure 8 Turbomolecular pump start delay with XDD1 diaphragm pump
4.9.2 Connect a vacuum gauge
A single compatible active gauge can be fitted to the pumping system.
Fit the gauge using an our active gauge cable into the gauge connector located on the
side of the controller housing. For active gauge control and set up refer to
on page 28.
The following are our active gauges which are suitable for use with the pumping system:
▪
APG100 Active pirani vacuum gauge
▪
APGX-H Active linear convection gauge
▪
AIM-X Active inverted magnetron gauge
▪
ASG Active strain gauge
▪
WRG Wide range gauge
D39595880_A
D39595880_A - Installation
Page 23
Gauge screen
10/2020 - ©Edwards Limited