Power Supply Regulation Modes; Constant Voltage (Cv); Constant Current (Cc); Automatic Mode Crossover - Xantrex XPR 10-600 Operating Manual

Power Supply Regulation Modes

The power supply has 2 regulation modes while in the Normal Operation State:
•
•
The CV and CC annunciators indicate the regulation mode.
Constant In this mode, the supply's output voltage is constant while the current and power
vary with the load. The power supply will operate in constant voltage mode
Voltage (CV)
whenever the load current I
(I
voltage at the selected value (V
requirements.
Constant In this mode, the supply's output current is constant while the voltage and power
vary with the load. The power supply will operate in constant current mode
Current (CC)
whenever the load resistance is low enough that the load current I
current limit setting I
maintains the output current at the selected value (I
varies with the load requirements.
Automatic
This feature allows the power supply to automatically switch operating modes in
Mode response to changing load requirements. If, for example, the power supply was
operating in Constant Voltage (CV) Mode (I
Crossover
load current (I
supply would automatically switch into Constant Current (CC) Mode and the output
voltage would vary in response to changes in load current. If the additional load was
subsequently removed so the load current was again LESS THAN the current limit
setting, the supply would automatically return to Constant Voltage (CV) Mode.

Remote Control Modes

Two analog control interfaces are available. You can control the power supply
remotely using 0–5V or 0–10V signals via the remote analog programming interface
or via remote resistive programming interface using 0-5kΩ or 0-10kΩ adjustable
resistors.
Release 1.1

Constant Voltage (CV)

Constant Current (CC)

=V /R ). In constant voltage mode, the power supply maintains the output
L SET L
SET
) became EQUAL TO the current limit setting (I
L
is less than the current limit setting I
L
) while the load current I
SET
. (V =I R ). In constant current mode, the power supply
L SET L
L
Power Supply Regulation Modes
SET
varies with the load
L
L
) while the load voltage V
SET
< I ), and the load changed so the
SET
SET
Operation
, or: I <I .
L SET
is equal to the
L
), the power
49