Automatic Storage Of System Parameters; Updating The Firmware - WAGO -SPEEDWAY 767 Manual

WAGO-SPEEDWAY 767
767-4804/000-800 8DO 24V DC 2.0A IF (4xM12)
Pos : 30.21 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung 767- xxxx Speicherung von Systemparametern @ 5\mod_1249380126156_21.doc x @ 40288 @ 2 @ 1
7.5

Automatic Storage of System Parameters

Some fieldbus couplers provide the "System Parameter Handling" feature. This
serves to identify changes to the configuration of a 767 Series node and to the
automatic configuration of the I/O modules. When an I/O module must be
replaced due to a defect, you do not need to reconfigure the new I/O module. The
stored parameters are automatically transferred to the new I/O module. Detailed
information on this procedure can be found in the fieldbus coupler manuals in the
"Parameter Setting via FDT/DTM" section.
Pos : 30.22 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung 767- xxxx Aktualisier ung der Firmwar e @ 7\mod_1265881922171_21.doc x @ 50306 @ 2 @ 1
7.6

Updating the Firmware

When updating the module firmware, the saved module parameters can be
overwritten. Therefore, check your existing configuration after updating the
firmware.
Pos : 31 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Parameterizing 57