8. Adhere the tape to the bottom lens support block.
9. Remove the remaining adhesive covering.
10. Position the bottom lens support block on the bottom of the projector lens cavity.
11. Insert the screws head into the hexagonal recess.
12. Adjust the brass knurled nut until the kit is snug between the lens and the bottom of the
projector lens cavity.
Replacing the ILS lens connector
Complete the following procedure to replace the ILS lens connector.
Estimated time to replace: 15 minutes.
1. Remove the lens (on page 82).
2. Place the lens on a flat surface.
3. Loosen the two cover screws.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
77