Removing The Lvds Cables; Removing The Image Processor Card - Christie J Series Service Manual

7. Remove the three screws from the bottom of the card cage.
8. Remove the input panel.
9. To break the connection to the passive backplane, from the underside of the panel driver, push
up.
10. Remove the panel driver.
11. To re-install, follow these steps in reverse order.

Removing the LVDS cables

Complete the following procedure to remove the LVDS cables.
Estimated time to replace: 35 minutes.
1. Remove the light engine (on page 68).
2. Disconnect the blue, green, and red DMD engine cables from the light engine.
3. Remove the LVDS cables.
4. To re-install, follow these steps in reverse order.

Removing the image processor card

Complete the following procedure to remove the image processor card.
Estimated time to replace: 1 minute.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Electronics
49