Replacing The Ir Remote Keypad; Remove The 3D Stereo Sync Cable - Christie J Series Service Manual

2.0, 2.4, and 3.0 kw

Hide thumbs Also See for J Series:

Table of Contents

8. Remove and replace the passive backplane module.

9. To re-install, follow these steps in reverse order.

Replacing the IR remote keypad

Complete the following procedure to replace the IR remote keypad.

Estimated time to replace: 1 minute.

1. On the side of the remote keypad, disconnect the 3.5 mm phono connector.

2. On the rear input panel of the projector, disconnect the XLR connector.

3. Remove and replace the wired cable.

4. If necessary, replace the remote keypad.

5. To re-install, follow these steps in reverse order.

Complete the following procedure to remove the 3D stereo sync cable.

Estimated time to replace: 1 minute.

J Series Service Guide–2.0, 2.4, and 3.0 kW

020-100739-05 Rev. 1 (02-2018)

Electronics

Table of Contents