5. Disconnect the P17 cable connector from the panel driver and then release it from the four
cable clamps.
6. Remove the four screws from the light engine duct.
7. Remove the shutter harness, harness from cable clips.
8. Remove the two screws securing the shutter assembly to the light engine.
9. Remove the shutter assembly.
10. To re-install, follow these steps in reverse order.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
67