4. Remove the lens motor cover.
5. Remove the two screws securing the motor pack to the lens barrel.
6. Remove the motor pack.
7. To remove the connector and motor pack from the barrel, loosen the two screws located on
each side of the connector.
For convenience, cut the tie wrap.
8. Before removing any pins from the original connector, place the replacement connector beside
the broken connector in the same orientation.
9. Insert the pin removal tool into the connector.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Optics
78