Removing the LCD display
Complete this procedure to remove the LCD display.
Estimated time to replace: 6 minutes.
1. Remove the rear cover (on page 37).
2. Remove the four screws securing the keypad cover.
3. Remove the four screws from the LCD display.
4. Disconnect the LCD display connector.
5. Remove and replace the LCD status display.
6. To re-install, follow these steps in reverse order.
Removing the projector keypad assembly
Complete the following procedure to remove the projector keypad assembly.
Estimated time to replace: 6 minutes
1. Remove the rear cover (on page 37).
2. Remove the four screws securing the keypad cover.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright
2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Electronics
54