Replacing The Connector Board - Christie GS Series Service Manual

5. To re-install, follow these steps in reverse order.

Replacing the connector board

The connector receives command codes from the mainboard to control the lens shift operation.
1. Remove the top cover.
See Removing the top cover
2. Remove the four M3 screws with a Phillips #1 screwdriver securing the front shielding.
3. On the connector board, disconnect the ten connectors, indicated by the arrows in the image
below.
See the table below for descriptions of each connector.
Item Male connector on
connector board
O
J7 ZOOM & FOCUS
P J3 HR
Q J4 VT
GS Series 630-635 Service Manual
020-001224-02 Rev. 1 (08-2018)
on page 51.
X W
V
O
P Q R S T
Description
Composed of white, yellow, pink, brown, black, and red
wires, a white connector (six pin)
Composed of two red wires, a white connector, and a
black wire tube (two pin)
Composed of two blue wires, a white connector, and a
black wire tube (two pin)
Printed circuit boards and sensors
U
Figure
74