Remove The Ac Relay Module - Christie J Series Service Manual

2. Remove the three screws (A) securing the convenience light board bracket to the rear cover.
3. Open the four retaining clips (B) to release the convenience light board.
4. Disconnect the wire harnesses (C) from the convenience light board.
The lens side board has one harness (top), the non-lens side board has two harnesses (top
and bottom).
A Screws
B Wire clips
C Harnesses
5. Remove the convenience light board.
6. To re-install, follow these steps in reverse order.

Remove the AC relay module

Complete the following procedure to remove the AC relay module.
Warning! If not avoided, the following could result in death or serious injury.
• SHOCK HAZARD! Disconnect the product from AC before installing, moving, servicing, cleaning,
removing components, or opening any enclosure.
Estimated time to replace: 6 minutes.
1. Remove the non-lens side cover (on page 38).
2. Remove the nut and washer from the starter capacitor.
3. Move the capacitor out of the way.
4. Disconnect the P59 and P60 connectors from the AC relay module.
5. Remove the four screws securing the AC relay.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Electronics
56