Christie J Series Service Manual page 52

3. Remove the rear cover (on page 37).
4. Remove the eight screws from the AC cover panel.
5. To access the AC power switch, pull the left side of the AC cover panel towards you while you
slide the right side and pull it forward.
6. To remove the AC line filter on 3.0 kW models:
a) Disconnect the two inlet connectors and the two outlet connectors from the AC line filter.
b) Remove the two screws securing the AC line filter.
c) Remove the AC line filter.
7. To remove the AC line filter on 2.0 kW and 2.4 kW models:
a) Remove the power cord retaining clip and the two screws securing it.
b) Disconnect the three AC line filter connectors.
c) Remove the AC line filter.
8. To re-install, follow these steps in reverse order.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Electronics
52