Replacing The Rear Non-Lens Side Bottom Stacking Mount - Christie J Series Service Manual

Replacing the rear non-lens side bottom
stacking mount
Complete the following procedure to replace the rear non-lens side stacking mount on the bottom of
the projector.
Estimated time to replace: 7 minutes.
1. Remove the non-lens side cover (on page 38).
2. Remove the locking screw from the stacking mount bolt.
3. Unscrew the stacking mount until it releases from the projector.
4. To replace the stacking mount, complete this procedure in reverse order.
5. To re-install, follow these steps in reverse order.
J Series Service Guide–2.0, 2.4, and 3.0 kW
020-100739-05 Rev. 1 (02-2018)
Copyright 2018 Christie Digital Systems USA, Inc. All rights reserved.
©
Stacking mounts
43